How Combustion Works: Fuel, Oxygen and Heat
Combustion is a fast chemical reaction in which a fuel combines with oxygen and gives off heat and light. When the burn is complete, the carbon in the fuel ends up as carbon dioxide (CO2) and the hydrogen ends up as water vapor (H2O). The heat comes out of that reaction. The fuel does not simply vanish.
The details are less obvious than they sound. The CO2 from a gallon of gasoline weighs about three times as much as the gasoline, a liquid fuel burns as vapor rather than as liquid, and wood burns in stages. The sections below follow the chemistry with two fuels from the Comparator, gasoline and wood, and leave the hardware to how a gasoline engine burns fuel.
Three ingredients and a start
The U.S. National Park Service teaches fire as a triangle: oxygen, fuel and heat, and fire occurs only if all three are present. Oxygen is plentiful in air. Fuel is anything that can react with it. Heat gets the reaction going: the Park Service says an external source of heat is usually needed to start combustion, and that a fire, once started, produces the heat that keeps it burning. Without any one of the three, there is no fire.
Liquid fuels burn as vapor
A pool of gasoline does not burn as a liquid. What ignites is the vapor above it, mixed with air. The Occupational Safety and Health Administration (OSHA) defines the flash point as the lowest temperature at which a liquid gives off enough vapor to form an ignitable mixture with air near its surface.
The DOE Alternative Fuels Data Center (AFDC) lists a flash point of -45°F (-43°C) for gasoline (its gasoline/E10 column) and 165°F (74°C) for low-sulfur diesel. Gasoline gives off ignitable vapor even in deep cold, while diesel has to be warmed well above room temperature first. A flash point says how easily a liquid makes vapor. It does not say how much energy the fuel holds. Gaseous fuels skip this step, since they are already vapor.
Complete combustion, atom by atom
EPA describes gasoline combustion as a split and a recombination. The fuel's carbon and hydrogen come apart, the hydrogen pairs up with oxygen to make water, and the carbon pairs up with oxygen to make CO2. Octane (C8H18), a single hydrocarbon, stands in for gasoline here to keep the arithmetic clean. The balanced reaction is:
C8H18 + 12.5 O2 → 8 CO2 + 9 H2O + heat
| Substance | Moles | Molar mass (g/mol) | Mass (g) |
|---|---|---|---|
| Octane (fuel) | 1 | 114 | 114 |
| Oxygen (from air) | 12.5 | 32 | 400 |
| Total going in | 514 | ||
| Carbon dioxide | 8 | 44 | 352 |
| Water | 9 | 18 | 162 |
| Total coming out | 514 |
The totals match: nothing is lost, atoms are rearranged. Each gram of octane yields 352 ÷ 114, or about 3.1 g, of CO2, because most of the CO2's mass comes from oxygen taken from the air. EIA gives the same reasoning with carbon: carbon's atomic weight is 12 and CO2's is 44, a ratio of about 3.67. EPA's figure for a real gallon points the same way: a gallon of gasoline weighs about 6 lb, and burning it produces 8,887 g of CO2, roughly 20 lb.
The question of how to count the energy that leaves as water vapor is the subject of higher vs lower heating value. The CO2 released per unit of energy for different fuels is in CO2 emissions per unit of energy.
How wood burns in stages
Wood is a solid, so it cannot burn the way a gas does. West Virginia University Extension describes three phases.
- Drying. The moisture in the wood is heated to boiling and leaves as steam, which uses some of the wood's own energy. For fresh wood at 50% moisture, about 13% of the energy goes to boiling off water. For air-dried wood at 15% moisture, it is about 2%.
- Gases and flame. Heating breaks large molecules into combustible gases and tar. The smoke ignites at about 540°F (282°C) and burns as flame. The secondary gases released next hold up to 60% of the wood's potential heat, and they burn only with enough oxygen and a temperature of at least 1,100°F (593°C).
- Charcoal. What remains is almost pure carbon. It glows and burns at 1,100 to 1,900°F (593 to 1,038°C) and burns slowly.
Wood combustion is therefore a sequence, with gas flames first and a carbon glow last. Moisture is treated in more detail in biomass and wood as fuel.
When burning is incomplete
Complete combustion needs enough oxygen. When carbon is only partly oxidized, the products include carbon monoxide (CO). EPA says carbon monoxide results from incomplete oxidation of carbon in combustion, and it lists gas ranges, unvented gas or kerosene heaters, and gasoline-powered equipment among the sources. In a wood fire, smoke that fails to burn leaves through the chimney as creosote or wood smoke, WVU Extension notes, and it carries away a large part of the wood's potential energy. Follow manufacturer instructions and local rules for any burning appliance.
Burning produces other pollutants too, and they are covered in air pollutants from burning fuels.
Common mistakes
- "Burning makes fuel disappear." Atoms are rearranged. In the octane example, 514 g goes in and 514 g comes out, and the exhaust is heavier than the fuel because the oxygen comes from air.
- "Liquid gasoline burns." The vapor burns. That is why a liquid's flash point matters.
- "Water in the exhaust means the fuel was wet." Hydrogen inside the fuel makes water when it burns, as EPA's description of gasoline combustion shows.
- "Complete combustion means harmless exhaust." Complete means the carbon becomes CO2 and the hydrogen becomes water. CO2 is still released.
- "Wet and dry wood differ only in speed." Wet wood spends more of its own energy on boiling off water: about 13% for fresh wood against about 2% for air-dried wood, per WVU Extension.
- "Fire needs only fuel and a flame." The Park Service says fire needs oxygen, fuel and heat together.
Frequently asked questions
Why does burning a gallon of gasoline produce more CO2 than the gasoline weighs?
Because the CO2 is built from the fuel's carbon plus oxygen from the air. Carbon's atomic weight is 12 and CO2's is 44, so each unit of carbon becomes about 3.67 units of CO2. EPA puts a gallon of gasoline at about 6 lb and its CO2 at roughly 20 lb.
Can a fuel burn without oxygen?
Not in ordinary fire. The National Park Service states that fire can occur only if oxygen, fuel and heat are all available. In everyday burning, the oxygen comes from the surrounding air. A log, gasoline vapor and a gas flame all need it, and the CO2 and water they produce are built from the fuel's carbon and hydrogen plus that oxygen.
What is incomplete combustion?
It is burning that stops short, so carbon is only partly oxidized. Carbon monoxide is one result, according to EPA. In wood fires, unburned smoke is another. The fuel still releases some heat, but it gives up less than it could, and the exhaust contains more unwanted products.
Where does the water in exhaust come from?
From the hydrogen in the fuel. Each hydrogen atom combines with oxygen to form water, as in the octane example, where one molecule of octane yields nine molecules of water. Fuels with more hydrogen produce more water vapor per unit of fuel burned.
Sources
- Greenhouse Gas Emissions from a Typical Passenger Vehicle: U.S. Environmental Protection Agency. Accessed November 13, 2026.
- Why do carbon dioxide emissions weigh more than the fuel they originated from?: U.S. Energy Information Administration. Accessed November 13, 2026.
- Meeting the Fire Triangle 2: U.S. National Park Service. Accessed November 13, 2026.
- 29 CFR 1910.106, Flammable liquids: Occupational Safety and Health Administration. Accessed November 13, 2026.
- Fuel Properties Comparison: U.S. Department of Energy, Alternative Fuels Data Center. Accessed November 13, 2026.
- Is Wood a Good Energy Source for Home Heating?: West Virginia University Extension Service. Accessed November 13, 2026.
- What is carbon monoxide?: U.S. Environmental Protection Agency. Accessed November 13, 2026.
- Octane: NIST Chemistry WebBook, SRD 69. Accessed November 13, 2026.
Spotted something wrong or out of date? Tell us through the corrections page. We answer within 10 business days.