Fuel basics

Energy Density Explained: Per Kilogram vs Per Liter

Large industrial storage tanks with green railings against a clear blue sky
Photo by Jan van der Wolf on Pexels. A general illustration, not evidence for any number.

Energy density has two common meanings: the energy in a kilogram of fuel (energy per mass) and the energy in a liter of fuel (energy per volume). The two rankings can disagree sharply. Among the four fuels in this article, hydrogen holds the most energy per kilogram and the least per liter.

The reason is density, meaning how much a liter weighs. Energy per liter equals energy per kilogram multiplied by kilograms per liter. This page puts four fuels on one basis, lower heating value (LHV), shows that multiplication with a worked example, and explains which of the two numbers fits which question. You can see all four side by side in the Comparator.

Two measures, two names

The U.S. Department of Energy (DOE) separates the two ideas in a review of aviation fuels. It calls energy per unit mass specific energy, measured in MJ/kg, and energy per unit volume energy density, measured in MJ/L. It adds that specific energy matters most for mass-limited uses and energy density for volume-limited ones. Many sources use "energy density" for both, so check the unit: MJ/kg or Btu/lb is per mass, while MJ/L or Btu/gal is per volume. The units themselves are explained in Btu, joule and kWh.

All figures below are LHV, which leaves out the heat in water vapor from burning. Mixing LHV and higher heating value (HHV) figures in one comparison creates errors, as higher vs lower heating value shows.

Four fuels, two rankings

Energy per kilogram and per liter on an LHV basis. Gasoline is the no-ethanol blend; hydrogen is uncompressed gas at 32°F (0°C) and 1 atm.
FuelPer kilogramPer literWeight of a liter implied by the two columns
Gasoline43.45 MJ/kg (18,680 Btu/lb)32.36 MJ/L (116,090 Btu/gal)0.745 kg
Diesel43 MJ/kg (18,487 Btu/lb)35.81 MJ/L (128,488 Btu/gal)about 0.83 kg
Ethanol (E100)26.95 MJ/kg (11,587 Btu/lb)21.27 MJ/L (76,330 Btu/gal)0.789 kg
Hydrogen (gas)120 MJ/kg (51,585 Btu/lb)0.01081 MJ/L (290 Btu/ft³)0.00009 kg (0.09 g)

Diesel's per-kilogram value is a generic IPCC default with a published range of 41.4 to 43.3 MJ/kg, and its per-liter value comes from a different publication, so its implied weight is approximate.

Read down the per-kilogram column and hydrogen is first, about 2.8 times gasoline (120 ÷ 43.45). Read down the per-liter column and the order flips. Diesel leads, about 11% above gasoline (35.81 ÷ 32.36). Ethanol shows how weight changes a gap. It holds about 62% of gasoline's energy per kilogram (26.95 ÷ 43.45) but about 66% per liter (21.27 ÷ 32.36), because a liter of ethanol weighs more than a liter of gasoline. Hydrogen gas falls to the bottom: gasoline holds about 3,000 times more energy per liter (32.36 ÷ 0.01081).

Diesel and gasoline show the mechanism in a quieter form. Their per-kilogram values are nearly the same, yet their per-liter values differ by about 11%. A liter of diesel must therefore weigh more than a liter of gasoline. The DOE aviation review says the same thing in general terms: a fuel's hydrogen-to-carbon ratio largely sets its specific energy, while its liquid density mostly sets its energy density.

Worked example: the same energy counted two ways

Take 10 L (about 2.6 US gal) of gasoline.

  • Energy: 10 L × 32.36 MJ/L = 323.6 MJ (about 307,000 Btu).
  • Mass: 323.6 MJ ÷ 43.45 MJ/kg = 7.45 kg (about 16.4 lb).

Now supply the same 323.6 MJ with hydrogen.

  • Mass: 323.6 MJ ÷ 120 MJ/kg = 2.70 kg (about 5.9 lb), about 36% of the gasoline's weight (2.70 ÷ 7.45).
  • Volume as uncompressed gas: 323.6 MJ ÷ 0.01081 MJ/L = about 29,900 L (about 7,900 US gal), nearly 3,000 times the gasoline's volume.

The implied weights check out against a direct source. Dividing 32.36 by 43.45 gives 0.745 kg per liter of gasoline, and Oak Ridge National Laboratory (ORNL) lists gasoline at 2,819 g per gallon, which is the same 0.745 kg per liter. Dividing 0.01081 by 120 gives about 0.00009 kg per liter of hydrogen, or 0.09 g, and ORNL lists hydrogen gas at 2.55 g per cubic foot, again about 0.09 g per liter. A gas is mostly empty space, so a liter of it holds little fuel.

Compression and cooling change that. DOE notes that storing hydrogen as a gas typically takes high-pressure tanks (350 to 700 bar, or 5,000 to 10,000 psi), and storing it as a liquid takes cryogenic temperatures, since its boiling point at ambient pressure is -252.8°C (-423°F). Those methods raise the energy per liter of the storage form, not the energy per kilogram of hydrogen, which stays at 120 MJ/kg. The details belong to hydrogen as a fuel.

Which number answers which question

Use energy per mass when weight is the limit and energy per volume when space is the limit. DOE's aviation review draws exactly that line: specific energy matters for mass-limited missions and energy density for volume-limited ones. The same split applies to gas, liquid and solid fuels in general, which solid, liquid and gaseous fuels covers. Liquids tend to rank well per liter because they are dense. Gases need compression or liquefaction to compete.

A per-volume yardstick also sits behind the gasoline gallon equivalent, which restates other fuels in terms of the energy in a gallon of gasoline. Remember that these figures describe the fuel alone. A tank, cylinder or container adds weight and takes up space of its own.

Common mistakes

  • Treating "energy density" as one number. Per kilogram and per liter are different measures and can rank fuels in opposite orders.
  • Assuming the fuel with the most energy per kilogram needs the smallest tank. Hydrogen leads per kilogram and trails per liter as an uncompressed gas.
  • Assuming a higher per-liter value means a higher per-kilogram value. Diesel is about 11% above gasoline per liter and about level with it per kilogram.
  • Comparing figures on different bases. An LHV value set against an HHV value, or a gas at one pressure against a gas at another, produces a gap that has nothing to do with the fuels.
  • Mixing up Btu per pound and Btu per gallon. The first is energy per mass, the second per volume, and the same fuel gives very different numbers for each.

Frequently asked questions

Which fuel has the most energy per kilogram?

Among gasoline, diesel, ethanol and hydrogen, hydrogen, at 120 MJ/kg on an LHV basis, about 2.8 times gasoline's 43.45 MJ/kg. DOE states that hydrogen has the highest energy per mass of any fuel. The same DOE page describes its energy per unit volume as very low.

Why does diesel hold more energy per liter than gasoline?

Because a liter of diesel weighs more, while the energy per kilogram is nearly the same. Gasoline carries 43.45 MJ/kg and diesel about 43 MJ/kg, but diesel's 35.81 MJ/L beats gasoline's 32.36 MJ/L. More mass in each liter means more energy in each liter.

What is the difference between specific energy and energy density?

In DOE's usage, specific energy is energy per unit mass (MJ/kg) and energy density is energy per unit volume (MJ/L). Outside technical writing, "energy density" often means either one, so the unit attached to the number is the safest guide to which measure is meant.

Why is hydrogen's energy per liter so low?

Hydrogen gas is extremely light. At 32°F (0°C) and 1 atm, a liter weighs about 0.09 g, so a liter carries only 0.01081 MJ even though each kilogram carries 120 MJ. Pressure or cold can pack more hydrogen into each liter, and DOE describes tanks rated for 350 to 700 bar as well as cryogenic liquid storage.

Sources

Spotted something wrong or out of date? Tell us through the corrections page. We answer within 10 business days.