Higher vs Lower Heating Value: What the Difference Means
Higher heating value (HHV) and lower heating value (LHV) are two ways to state how much heat a fuel releases when it burns. They differ in one detail: whether the energy tied up in water vapor from combustion is counted. HHV counts it, as if the water condensed back to liquid. LHV leaves it out. One fuel therefore has two correct numbers, and the HHV is the larger.
Choosing between them is less a question of right and wrong than of matching. Mixing the two shifts a result by roughly 2% to 10% for most fuels and by more for hydrogen or wet wood. This page shows the gap for hydrogen, natural gas and gasoline using the Comparator numbers, derives hydrogen's gap from the properties of water, and gives a rule for picking a basis.
Where the water comes from
Fuels that contain hydrogen make water when they burn, as how combustion works shows. The U.S. Energy Information Administration (EIA) says heat content can be stated as gross (higher) or net (lower), depending on whether the heat energy counted includes or excludes the energy used to vaporize water, whether that water was in the fuel or was created in the flame.
Oak Ridge National Laboratory (ORNL) spells out the conditions. For LHV, a fuel starts at 25°C and the combustion products are returned only to 150°C, so the latent heat of vaporization of the water is not recovered. For HHV, the products return to 25°C, so that latent heat is counted. ORNL adds that LHV goes by the name net calorific value and HHV by gross calorific value, that LHV is frequently used in Europe, and that HHV values are derived only under laboratory conditions.
How big is the gap?
EIA states that the difference generally ranges from 2% to 10%, depending on the fuel and its hydrogen content, and that some fuels, such as unseasoned wood, differ by more than 40% between gross and net values. A fuel with more hydrogen makes more water per unit of heat, so its gap is wider.
| Fuel and basis | LHV | HHV | HHV compared with LHV |
|---|---|---|---|
| Hydrogen, per kilogram | 120 MJ/kg (51,585 Btu/lb) | 141.9 MJ/kg (61,013 Btu/lb) | about 18% higher |
| Natural gas (CNG), per kilogram | 46.89 MJ/kg (20,160 Btu/lb) | 52.23 MJ/kg (22,453 Btu/lb) | about 11% higher |
| Gasoline, per gallon | 32.36 MJ/L (116,090 Btu/gal) | 34.66 MJ/L (124,340 Btu/gal) | about 7% higher |
The percentages come from simple division: 141.9 ÷ 120 = 1.18; 52.23 ÷ 46.89 = 1.11; 124,340 ÷ 116,090 = 1.07. The order follows hydrogen content. Hydrogen is pure hydrogen, natural gas is mostly methane, and gasoline has the smallest hydrogen share of the three. Hydrogen's 18% lies above the 2% to 10% that EIA gives as the general range, and natural gas at about 11% sits just above it. The rows also use different forms (per kilogram or per gallon), so read the percentages as a pattern, not as a ranking of fuels.
Worked example: where hydrogen's gap comes from
The table's gap for hydrogen is 141.9 − 120 = 21.9 MJ per kilogram. Water's properties explain nearly all of it.
- Moles of hydrogen. NIST lists the molar mass of hydrogen (H2) at 2.01588 g/mol, so 1 kg is 1,000 ÷ 2.01588 = about 496 mol.
- Moles of water. Burning H2 makes one mole of water per mole of hydrogen, so 496 mol of H2O.
- Latent heat per mole. NIST's saturation table for water at 25°C gives vapor enthalpy of 45.876 kJ/mol and liquid enthalpy of 1.8885 kJ/mol. The difference, the energy to vaporize one mole, is 43.99 kJ/mol.
- Total. 496 mol × 43.99 kJ/mol = about 21,800 kJ, or 21.8 MJ.
That is within about 0.4% of the 21.9 MJ/kg gap in the table. Nearly all of the gap between the two heating values is the heat of condensing the exhaust water.
Which one should you use?
Use the one that matches every other number in the comparison, and label it. In practice, the choice often follows convention:
- EIA applies gross values in all Btu calculations for its Monthly Energy Review, and notes that net values are typically used in European energy calculations.
- ORNL notes that HHV is frequently used in the United States for solid fuels.
- EPA's catalog of combined heat and power technologies (2015) states that turbine and engine manufacturers quote heat rates on an LHV basis, while electric utilities measure power plant heat rates on an HHV basis. It puts the ratio of LHV to HHV at about 0.9 for natural gas, which agrees with the table (46.89 ÷ 52.23 = 0.90).
- EPA's emission factors are published per unit of HHV energy, and the Comparator keeps them on that basis.
A hypothetical shows why the label matters. Suppose a machine delivers 40,000 Btu of useful output from 1 gallon of no-ethanol gasoline. Against the LHV of 116,090 Btu, that is 40,000 ÷ 116,090 = 34.5%. Against the HHV of 124,340 Btu, it is 40,000 ÷ 124,340 = 32.2%. The machine did not change, but the quoted efficiency moved 2.3 percentage points. Those numbers are an illustration, not a measurement of any real device. Units for these conversions are in Btu, joule and kWh, and per-kilogram versus per-liter comparisons are in energy density by mass and volume.
Common mistakes
- Treating one value as the "true" heating value. Both are correct under their own assumptions about the water. They answer slightly different questions.
- Reading a mismatch between sources as an error. A fuel can show different energy figures because one source reports HHV and the other LHV.
- Assuming every fuel has the same gap. EIA gives 2% to 10% for typical fuels, the table shows 18% for hydrogen, and EIA says unseasoned wood can exceed 40%.
- Comparing an efficiency quoted on LHV with one quoted on HHV. The same machine looks about two points better on LHV in the example above.
- Expecting a real device to recover the HHV. ORNL notes that HHV values are derived only under laboratory conditions.
- Thinking the basis changes the CO2 a fuel makes. The chemistry is the same. Only the energy total in the denominator of a per-energy factor moves.
Frequently asked questions
What is the difference between HHV and LHV in simple terms?
Both measure the heat from burning a fuel. HHV adds the energy released when the water vapor in the exhaust condenses to liquid, and LHV does not. The fuel and the fire are identical. Only the accounting differs, so HHV is the larger of the two numbers.
Which heating value does the United States use?
Mostly HHV for national statistics: EIA uses gross values in its Btu calculations. Practice varies by field, though. ORNL notes HHV is frequently used for solid fuels in the U.S., and EPA says engine and turbine manufacturers quote LHV. Always check the label next to a number.
Why is hydrogen's gap so large?
Hydrogen contains no carbon, so burning it makes water in place of CO2. Each kilogram yields about 496 mol of water, and condensing that water adds about 21.8 MJ, which is roughly 18% of hydrogen's LHV of 120 MJ/kg. Hydrocarbons such as gasoline also make CO2, so water is a smaller share of their products.
Does the choice change how much CO2 a fuel emits?
No. Burning a given amount of fuel releases the same CO2 whichever heating value you cite. What changes is the energy total used when expressing emissions per unit of energy. The Comparator keeps its CO2 factors on EPA's per-HHV basis and labels each energy figure as LHV or HHV.
Sources
- Glossary, entry "Heat content": U.S. Energy Information Administration. Accessed November 13, 2026.
- British Thermal Unit and Other Conversion Factors: U.S. Energy Information Administration. Accessed November 13, 2026.
- Fuel Properties Comparison: U.S. Department of Energy, Alternative Fuels Data Center. Accessed November 13, 2026.
- Lower and Higher Heating Values of Gas, Liquid and Solid Fuels (Biomass Energy Data Book, Appendix A, 2011): Oak Ridge National Laboratory, copy hosted by the University of Illinois. Accessed November 13, 2026.
- Catalog of CHP Technologies, Section 3. Technology Characterization, Combustion Turbines: U.S. Environmental Protection Agency, Combined Heat and Power Partnership. Accessed November 13, 2026.
- Hydrogen: NIST Chemistry WebBook, SRD 69. Accessed November 13, 2026.
- Thermophysical Properties of Water: NIST Chemistry WebBook, SRD 69. Accessed November 13, 2026.
- GHG Emission Factors Hub: U.S. Environmental Protection Agency, Center for Corporate Climate Leadership. Accessed November 13, 2026.
Spotted something wrong or out of date? Tell us through the corrections page. We answer within 10 business days.