CO2 Emissions per Unit of Energy: How Fuels Compare
Among the five fuels here, coal releases the most CO2 for each unit of energy released by burning, diesel and gasoline come next, propane is lower, and natural gas is lowest. EPA's factors put bituminous coal at 88.41 g of CO2 per megajoule (MJ) and natural gas at 50.29 g per MJ, so coal emits about 1.8 times as much for the same energy (88.41 ÷ 50.29 is about 1.76).
That ranking is a comparison by energy. Compare the same fuels by the gallon, the pound or the cubic foot and the gaps change size, because a gallon of one fuel holds far more energy than a gallon of another. These figures also count only the CO2 from burning, not mining, refining or leaks. The sections below give the numbers in three unit systems, explain why they differ, work through two examples, and list what the figures leave out. For the chemistry behind CO2 and heat, see from burning fuel to the greenhouse effect.
The ranking on one basis
| Fuel | g CO2 per MJ | kg CO2 per million Btu | lb CO2 per million Btu | g CO2 per kWh of heat | Relative to natural gas |
|---|---|---|---|---|---|
| Coal (bituminous) | 88.41 | 93.28 | 205.6 | 318 | 1.76 |
| Diesel (No. 2) | 70.1 | 73.96 | 163.1 | 252 | 1.39 |
| Gasoline | 66.56 | 70.22 | 154.8 | 240 | 1.32 |
| Propane | 59.59 | 62.87 | 138.6 | 215 | 1.18 |
| Natural gas (CNG) | 50.29 | 53.06 | 117 | 181 | 1.00 |
All five rows use energy measured as higher heating value, which is how EPA publishes them. You can view four of them together in the Comparator for coal, diesel, gasoline and natural gas, and the closest pair in the propane and natural gas comparison. The unit conversions behind the table are in Btu, joule and kWh.
A concrete case: releasing 1,000 kWh of heat (3,600 MJ, or 3.41 million Btu) from coal puts about 318 kg (700 lb) of CO2 into the air. The same heat from natural gas gives about 181 kg (400 lb), which is 137 kg less (318.3 − 181.0).
Other tables differ slightly. EIA publishes its own coefficients, last released September 18, 2024, and says they may vary slightly with estimation method and over time. EIA's bituminous coal figure is 205.57 lb per million Btu, close to EPA's 205.6. For gasoline, EIA lists 167.79 lb for gasoline without blended ethanol and 155.77 lb for finished gasoline that includes ethanol, treating the ethanol part as nonemissive. EPA's single motor gasoline factor does not say which case it covers. Compare fuels from one source and one edition.
Why fuels differ: carbon in each unit of heat
EIA says the CO2 from burning a fuel is a function of its carbon content. A fuel's heat content comes mainly from carbon and hydrogen combining with oxygen. Only the carbon makes CO2, while both carbon and hydrogen make heat, so a fuel with more hydrogen per carbon atom gives less CO2 for the same heat. EIA says natural gas is primarily methane, which has a higher energy content than other fuels, and links that to its lower CO2 relative to its energy. Water, sulfur and other noncombustible material do the opposite: they lower a fuel's heating value and raise its CO2 per unit of heat.
EPA's inventory guidance gives a practical reason to publish factors per energy unit: they vary less than factors per mass or volume, because a fuel's carbon content tracks its heat content more closely than its physical quantity. The same guidance says CO2 makes up more than 99% of the CO2-equivalent emissions from commercial, industrial and electricity-generation combustion sources in the United States. A CO2-only factor therefore captures nearly all of the burning emissions from those sources, although the guidance still says methane and nitrous oxide should be estimated.
How the unit changes the answer
Take liquids by the gallon. The arithmetic uses AFDC's higher heating values and EPA's factors, in million Btu per gallon times kg per million Btu:
- Gasoline (no ethanol): 0.12434 × 70.22 = about 8.7 kg of CO2 per gallon (19.2 lb).
- Diesel: 0.13849 × 73.96 = about 10.2 kg per gallon (22.6 lb).
- Propane: 0.09142 × 62.87 = about 5.7 kg per gallon (12.7 lb).
EPA's own table lists 8.78 kg per gallon for motor gasoline, based on a rounded 0.125 million Btu per gallon, so the gasoline figure depends on which energy value you pair with the factor. Per gallon, diesel is about 17% above gasoline (10.24 ÷ 8.73). Per unit of energy the gap is only about 5% (73.96 ÷ 70.22), because a gallon of diesel holds more energy. Propane looks about 34% lower than gasoline per gallon (5.75 ÷ 8.73 is 0.66), yet per unit of energy it is only about 10% lower (62.87 ÷ 70.22 is 0.90). A gallon of propane simply holds less energy. The method of putting different fuels on a common energy yardstick is in gasoline gallon equivalent.
What the figures leave out
These are combustion-only values. They exclude extraction, refining, transport and leaks, which a life-cycle count adds, and the two measures should never be merged. The difference is explained in combustion vs life-cycle emissions.
They also describe energy released, not energy delivered. A furnace, an engine and a power plant turn different shares of the fuel's energy into useful work, a topic covered in energy efficiency vs fuel efficiency. Finally, the table leaves out biomass fuels, whose CO2 EPA reports separately as biogenic.
Before comparing numbers from any source, check four things:
- Is the energy basis HHV or lower heating value?
- Is the unit energy, mass or volume?
- Does the number come from one source and one edition?
- Does it count burning only, or the whole chain?
Common mistakes
- Comparing fuels per gallon or per pound. A gallon of propane releases about a third less CO2 than a gallon of gasoline mostly because it holds less energy. Per unit of energy the gap is about 10%.
- Reading a combustion factor as a total footprint. It leaves out production and delivery.
- Mixing HHV and lower heating value. Divide the same CO2 by a smaller energy figure and the result per MJ rises. Keep one basis.
- Mixing sources and years. EIA and EPA tables can differ slightly, and the gasoline case shows how ethanol treatment changes a number.
- Assuming a low-CO2 fuel is low in everything. Natural gas has the lowest figure in this table, but air pollutants and methane leaks are separate measures with their own numbers.
Frequently asked questions
Which common fuel releases the least CO2 per unit of energy?
Of the five fuels in EPA's tables compared here, natural gas does: 50.29 g per MJ (53.06 kg per million Btu), on an HHV basis. Propane follows at 59.59 g per MJ, then gasoline at 66.56, diesel at 70.1 and bituminous coal at 88.41. These are burning-only figures.
How much more CO2 does coal release than natural gas?
For the same energy, bituminous coal releases about 76% more than natural gas: 88.41 g per MJ against 50.29 g per MJ, a ratio of about 1.76. Per kilowatt-hour of heat from the fuel, that is about 318 g against 181 g.
Why does a gallon of diesel release more CO2 than a gallon of gasoline?
A gallon of diesel holds more energy and has a slightly higher factor. Using HHV, diesel is 138,490 Btu per gallon at 73.96 kg per million Btu, giving about 10.2 kg. Gasoline without ethanol is 124,340 Btu per gallon at 70.22 kg per million Btu, giving about 8.7 kg.
Why do websites give different CO2 numbers for the same fuel?
Sources differ in edition, method and basis. EIA says its coefficients vary slightly with estimation method and across time. Some tables use lower heating value, some treat blended ethanol as nonemissive, and some count mass or volume instead of energy. Compare numbers from one source, one edition and one basis.
Sources
- GHG Emission Factors Hub: U.S. Environmental Protection Agency. Accessed November 13, 2026.
- Greenhouse Gas Inventory Guidance: Direct Emissions from Stationary Combustion Sources: U.S. EPA Center for Corporate Climate Leadership. Accessed November 13, 2026.
- Carbon Dioxide Emissions Coefficients: U.S. Energy Information Administration. Accessed November 13, 2026.
- How much carbon dioxide is produced when different fuels are burned?: U.S. Energy Information Administration. Accessed November 13, 2026.
- Alternative Fuels Data Center: Fuel Properties Comparison: U.S. Department of Energy. Accessed November 13, 2026.
Spotted something wrong or out of date? Tell us through the corrections page. We answer within 10 business days.