Natural Gas: What It Is and How Pipeline Gas, CNG and LNG Differ
Natural gas is a mixture of gases whose main component is methane, a molecule built from one carbon atom and four hydrogen atoms (CH4). Pipeline gas, compressed natural gas (CNG) and liquefied natural gas (LNG) are not three different fuels. They are one fuel held in three ways: under pipeline pressure, squeezed to very high pressure, or cooled until it becomes a liquid.
The word "mixture" matters as much as the word "methane." Gas from a well carries other hydrocarbons, water vapor and sometimes unwanted gases, and a processing plant cleans it before it enters a pipe. This article follows the gas from the ground to its three forms, then uses one gallon of gasoline as a yardstick to show how much room the same energy takes in each.
What natural gas is made of
Methane is the largest component, but it is not the only one. The U.S. Energy Information Administration (EIA) says gas straight from the well, called wet gas, usually also holds natural gas liquids: ethane, propane, butanes and pentanes. It can also hold water vapor, sulfur compounds, helium, nitrogen, hydrogen sulfide and carbon dioxide.
The mix changes from field to field. A Penn State course lists three raw-gas examples, from Canada, Kansas and Texas. Methane runs from about two-thirds to just over three-quarters of the gas in them, and nitrogen runs from 3.2 to 25.6 percent. The same course gives a reference table of limits for "pipeline quality" gas, which is the gas after processing.
| Component | Raw gas, three example fields | Pipeline-quality limit |
|---|---|---|
| Methane | 65.8 to 77.1 | at least 75 |
| Ethane | 3.8 to 6.6 | at most 10 |
| Propane | 1.7 to 3.7 | at most 5 |
| Butanes | 0.8 to 2.0 | at most 2 |
| Pentanes and heavier | 0.5 to 3.0 | at most 0.5 |
| Nitrogen | 3.2 to 25.6 | at most 3 (with other inert gases) |
| Carbon dioxide | 0 to 1.7 | at most 2 to 3 |
Individual pipelines set their own gas-quality rules, so treat the right-hand column as an illustration of the idea, not as one national standard.
From wellhead to pipeline gas
Processing plants remove water vapor and other non-hydrocarbon compounds and pull out the natural gas liquids, which are sold separately. What is left is called dry, consumer-grade or pipeline-quality gas. Propane is one of those separated liquids, which is why propane and LPG get their own article: propane leaves the gas stream long before the gas reaches a building.
Dry gas then moves through high-pressure, long-distance transmission pipelines, then through smaller mains and service lines into homes and businesses. Underground storage in depleted fields, salt caverns and aquifers evens out changing demand. How fuels are transported covers the movement side.
The finished gas is colorless, odorless and tasteless. Companies add mercaptan, a harmless chemical that smells like rotten eggs, so that people can notice a leak.
On energy, EIA reports that the U.S. average heat content of gas delivered to consumers was 1,036 Btu per cubic foot (about 1.09 MJ) in 2025, after 1,037 in 2024 and 1,036 in 2023. EIA typically reports gross heat content, so treat this as a higher heating value. The Penn State reference table that lists pipeline limits shows a wider band, 950 to 1,150 Btu per standard cubic foot, so one delivered average hides some variation. The Comparator's natural gas row uses another reference condition, 1,089 Btu per cubic foot (higher heating value) for uncompressed gas at 32 °F and 1 atm, so its figure runs about 5 percent above EIA's delivered-gas average. Higher vs lower heating value explains the two bases.
Pipeline gas, CNG and LNG side by side
Compressed natural gas is natural gas squeezed to less than 1 percent of its volume at standard atmospheric pressure. The U.S. Department of Energy's Alternative Fuels Data Center (AFDC) says vehicles store it at up to 3,600 pounds per square inch (about 248 bar).
Liquefied natural gas is the same gas cooled to about -260°F (-162°C), where it turns into a liquid about 600 times smaller than the gas in a pipeline, according to EIA. Cooling is not free: EIA estimates that about 7 to 15 percent of the gas entering an LNG plant is used up in the liquefaction process, mostly to run the plant's own equipment. LNG travels in super-cooled (cryogenic) tanks aboard ships and in smaller containers on ships and trucks. It exists mainly because it can reach markets that pipelines cannot, and because some ships, trucks and buses carry it as a fuel.
| Form | Condition | Volume compared with the gas at atmospheric pressure | What holds it |
|---|---|---|---|
| Pipeline gas | Gas under pipeline pressure | Baseline | Pipelines and underground storage |
| CNG | Compressed gas, up to 3,600 psi on a vehicle | Less than 1% | High-pressure vehicle tanks |
| LNG | Liquid at about -260°F (-162°C) | About 1/600 | Super-cooled (cryogenic) tanks |
AFDC adds that about 40 percent of U.S. natural gas goes to electric power and only about two-tenths of 1 percent to transportation fuel; its page gives no year for these shares. Vehicle fuel, whether CNG or LNG, is a small corner of natural gas use. Renewable natural gas, made by cleaning up biogas, is chemically identical to the fossil kind and can use the same equipment. Biogas and renewable natural gas covers how it is made.
How much energy each form holds
Energy per pound is the fair way to compare the forms, because squeezing or cooling a gas changes its volume but not its mass. AFDC lists CNG at 46.89 MJ/kg (20,160 Btu/lb) and LNG at 49.4 MJ/kg (21,240 Btu/lb) on a lower-heating-value basis. On a higher-heating-value basis the figures are 52.23 MJ/kg (22,453 Btu/lb) and 55.19 MJ/kg (23,726 Btu/lb). LNG comes out about 5 to 6 percent higher on either basis (49.4 ÷ 46.89 = 1.054 on LHV, 55.19 ÷ 52.23 = 1.057 on HHV). AFDC describes LNG as methane with inert gases below 0.5 percent, and CNG as methane with some ethane and inert gases, so the two columns describe slightly different mixtures. The table does not say that this explains the gap.
Volume is where the forms differ most, and a worked example makes the difference concrete. All figures here use the higher heating value.
- One gallon of ethanol-free gasoline holds 124,340 Btu.
- Pipeline gas holds 1,036 Btu per cubic foot, so 124,340 ÷ 1,036 is about 120 cubic feet.
- At atmospheric pressure, 120 cubic feet is about 900 gallons (1 cubic foot is about 7.48 US gallons).
- As CNG, at less than 1 percent of that volume, it needs under 1.2 cubic feet, or about 9 gallons of tank space.
- As LNG, at about 1/600 of the gas volume, it needs about 0.2 cubic feet, or about 1.5 gallons.
That final figure matches AFDC's rule of thumb that one gasoline gallon equivalent is about 1.5 gallons of LNG, a useful cross-check from a separate source. The formal yardstick is explained in gasoline gallon equivalent.
Burning is the same in all three forms. EPA publishes one natural gas factor, 53.06 kg of CO2 per million Btu (50.29 g CO2/MJ), and applies it to LNG as well. That counts only the CO2 released when the gas burns, which is a different measure from life-cycle emissions. You can see the numbers next to each other in the CNG and LNG comparison.
Common mistakes
- Treating natural gas as pure methane. Methane leads the mix, but raw gas also carries heavier hydrocarbons, water vapor, nitrogen and carbon dioxide, and the shares differ by field.
- Thinking CNG and LNG are different fuels. They are the same gas. CNG is compressed, LNG is cooled, and each choice trades equipment for space.
- Assuming natural gas smells on its own. It does not. The smell comes from an added chemical so that leaks can be noticed.
- Comparing a cubic foot of gas with a gallon of liquid. Volumes of different forms do not compare directly. Compare by mass, or convert both to energy first.
- Confusing natural gas with propane. Propane is one of the liquids separated out of wet gas, and it is a separate fuel with its own handling.
Frequently asked questions
What is natural gas made of?
Mostly methane, a one-carbon, four-hydrogen molecule. Wet gas from a well also contains ethane, propane, butanes, pentanes, water vapor, and sometimes nitrogen, carbon dioxide and sulfur compounds. Processing removes most of the extras, leaving dry pipeline-quality gas that is predominantly methane.
What is the difference between CNG and LNG?
CNG is natural gas compressed to less than 1 percent of its normal volume and stored at up to 3,600 psi. LNG is natural gas cooled to about -260°F so it becomes a liquid roughly 600 times smaller than the gas. CNG needs strong tanks; LNG needs insulated, super-cold ones.
Why does natural gas smell if it is odorless?
Natural gas has no odor of its own. Companies add mercaptan, a harmless chemical that smells like rotten eggs, so a leak can be noticed quickly. If you ever smell it, follow the instructions of your gas utility and local rules.
Sources
- Natural gas explained: U.S. Energy Information Administration. Accessed November 13, 2026.
- Liquefied natural gas explained: U.S. Energy Information Administration. Accessed November 13, 2026.
- Natural gas delivery and storage: U.S. Energy Information Administration. Accessed November 13, 2026.
- Heat content of natural gas delivered to consumers: U.S. Energy Information Administration. Accessed November 13, 2026.
- Natural Gas Basics: U.S. Department of Energy, Alternative Fuels Data Center. Accessed November 13, 2026.
- Fuel Properties Comparison: U.S. Department of Energy, Alternative Fuels Data Center. Accessed November 13, 2026.
- Natural Gas Composition and Specifications: Penn State, Department of Energy and Mineral Engineering. Accessed November 13, 2026.
- GHG Emission Factors Hub: U.S. Environmental Protection Agency. Accessed November 13, 2026.
Spotted something wrong or out of date? Tell us through the corrections page. We answer within 10 business days.